How to Prevent Root Rot in Aeroponic Cloners


How to Prevent Root Rot in Aeroponic Cloners

Have you tried cloning your plants in an aero cloner and haven't had much luck? Are the stems slimy and the roots rotting? Most of the time the reason is because you have made a common mistake.

The first thing that you need to do is make sure your cloner is completely clean, down to the pump's spinner. If you have to reuse the neoprene collars make you they have been cleaned very very thoroughly. Try to use food grade cleaners but bleach can be used if you have nothing else. If bleach is used make sure all residues have been rinsed out. If you think you've rinsed it out enough, do it one more time. There could be a few reasons why you are getting root rot.

Water Temperature - Make sure your water temperature isn't too high. In summer, the water temps can jump. Keep it around 70-75 degrees F and you should be good. Bacterial growth takes off in higher temps.

pH - Your pH level needs to be between 5.5-5.8 for aeroponics. This isn't soil or hydro, a pH of 6 is getting too high. If you don't have a digital pH meter you might want to get one. Hanna makes a really good Digital Waterproof pH/EC/TDS Tester that runs about $150. Make sure you pH test after adding anything to the water.

Preparing your cloner - Some people use a clone solution in their water but you don't necessarily have to. However, you can add 3% hydrogen peroxide to your water to help prevent nastiness. Add about 1 tablespoon (the measuring kind, not the one you eat with) per gallon of water.

Just follow these tips and you will be good to go!

Previous Post Next Post

  • Rogue Staff
Comments 0
Leave a comment
Your Name:*
Email Address:*
Message: *

Please note: comments must be approved before they are published.

* Required Fields
Register with Rogue Rewards for free to start earning points. Close